中文版  |   Favorites     
  Home About Us Products FeedBacK Contact Us  
 
 
Product Directory
Cast Iron Test Moulds
Plastic Test Mold
Car Repair Tools
Compression Testing Machine
Climate Chambers
Compression Testing Machine
Concrete Test Apparatus
Cement Test Apparatus
Soil Test Apparatus
Asphalt Test Apparatus
Aggregate Tester
The waterproof material testin
Lab Test Accessories
Electronic balance series
 
Contact Us
  Tel:086-317-5106220
      Skype:flm123
  Fax:+086-317-4633220
  Mobile phone: 086+13011998767
  E-mail:chinesemoulds@foxmail.com
  Skype:443229727@qq.com
  Website:http://www.chinesemoulds.com
  Address: No. 68 Nanguan Village, Xianxian County, Cangzhou City, Hebei Province
  Industry news You're Here: Index > News > Industry news >
Plate load tester preparatory work
DATE:2015-02-07 20:15  Form:未知   Click:

A, plate loading tester preparatory work is:

1, the load plate is placed in the experiment has flat point.

Truck 2, will be open to cooperation experiment experimental point some distance from the local, this distance should be less than 1 meters, and to the rear of the truck beam load plate located above the.

3, the jack is placed in the load board.

4, a device measuring bridge, make in a roughly symmetrical range ofexperimental points.

The elevating screw rolling 5, Jack, and makes the rear of the truck beamheight of touch, not, experimental extension rod.

6, a dial indicator device on the dial indicator bracket, and dial indicator measuring rod straight to the load measuring point.

Unit two, plate loading test instrument is:

1, the cradle beams uprights fixed to the ground, the distance should be 250mm, the two bearings should be flat, the column in the same straight line, the beams in the two bearings on the height to be the same.

2, connect the pump, pressure gauge pressure tubing, jack.

3, then the two outer beams were inserted into inner cross beam, in place and tighten the knob.

4, the whole measuring bridge beam height on the support column, in the distance the ground should be 300mm.

5, connect the pressure gauge and high pressure pipe

  Valve Seat Cutter,Skid Resistance Tester, Compression Testing Machine
Copyright © 2015-2016 Cangzhou Oubeiruike Instrument Equipment Co., Ltd.  冀icp备15002400